Browsing »

Nut Lifter

Nut Lifter

To get the nut started on the hinge bolts of the rudder and elevator, the illustrated “nut lifter” was devised. The off-set end is used at the main center hinges on both the elevator and rudder. The 5/32 rivets are driven and expanded to a size that will hold a quarter inch castle nut snugly. […]

List of Manuals and Blueprints

List of Manuals and Blueprints

Below is a list of Beech 18 Manuals and Drawings available.  Please call Shelley Warren for more info and pricing at (918) 272-9815. PartNumber Description M01-90CB-1 C45 “FLIGHT MANUAL,C45 BOX 7” M01-90CB-2 C45 “SERVICE MANUAL,C45 BOX 7” M01-90CB-3 C45 OVERHAUL INSTRUCT.C45 BOX 7 M01-90CE-1 UC45J “FLIGHT MANUAL,NATOPS BOX 8” M01-90KA-15 “TANK,NOSE,METAL BOX 6” M01-90KC-4 AT11 […]

Landing Light

Model D18S, No. 6  |  Reprinted:  October 26, 1951  |  TURNING LANDING LIGHTS “ON” OR “OFF” IN EXTENDED POSITION In order to improve the efficiency and operation of the landing lights, necessary wiring changes have been made on the Model D18S airplanes from Serial A133 and after to facilitate turning the landing light “on” or […]

Intensifier Tube Inspection

Intensifier Tube Inspection

Volume 2  |  April, 1949  |  Number 7  |  MODEL 18 SERVICE NOTES AND CHANGES The intensifier tubes and cabin heat valves on all Model 18 airplanes should be inspected at each 100-hour inspection for evidence of cracks and holes which would permit exhaust fumes to enter the cockpit and cabin through the heating system.  […]

Hinge Bolt Pliers

Hinge Bolt Pliers

Use of these pliers will save you hours over the minutes required to make them. They can be made from standard needle nose pliers and a piece of steel sheet or bar stock. Their advantage is that with them you can hold the quarter inch AN bolt and insert the bolt in the control surface […]

Window Seal

Window Seal

Model:  D18S, No. 4  |  Revised:  April 15, 1953  |  SEALING CABIN WINDOWS Cabin window are sealed in rubber by using a pressure strip (A), mounted in the window frame (B). In the event leaks occur around the edge of the window frame, the following procedure should be used as a guide. Remove trim strip […]

Hat Holder

Hat Holder

Model D18S, No. 1  | Kit 500 | Issued 8-6-46 | Revised 10-29-53 Hat holders are now available for your airplane and, if desired, may be installed on airplanes prior to A-220 as follows:

Goodyear Brakes

Goodyear Brakes

VOLUME 1  |  APRIL 1, 1948  |  NUMBER 7  |  MODEL 18 SERVICE NOTES AND CHANGES  |  GOODYEAR 11.00 X 12 BRAKES The Goodyear Tire and Rubber Company, Inc., has informed us of an improvement change which has been made to the 11.00 x 12 brake discs, used on the Model 18.  Instead of machining […]

« Previous Entries Next Entries »